UltraVoice™

Product Literature

Electronic Controller

Category: Command & Control

The UltraVoice™ controller combines micro-processor based system control with highly efficient amplifiers to deliver optimized tones and voice capability for Electronic Sirens. UltraVoice can generate and amplify single or dual warning tones and comes with seven pre-set signals. In addition, the controller has been designed specifically with high quality live or recorded voice reproduction capability.

New Features

Digitally Stored Message Capability up to 8 minutes – single chip design
Highly Efficient Pulse Width Modulated Amplifiers (67Vrms) – perfect for 70V speakers
30 Minute minimum run-time – no limitation on continuous signal (voice, music or tone)
8 Zones possible per controller – each amplifier can be a separate zone.
3200 Watts per controller – and still only four Delco M24MF batteries
Windows-based programming software – FS-MWIN or SFCDWARE (optional): FS-MWIN replaces MCPWIN
Plug-in Radio Receiver option
Additional report data – voltage and current report along with load
Calibration of the Load for distributed speakers – ability to “set” the load for supervision and quiet test – system will report a 20% change in load on any amp.

Features

Seven Standard Warning Signals
Two-Way Status Monitoring
Quiet Test (Standard)
Low Power Alert option Land-line or radio controlled
Battery Operated
Distinct Dual Tone Capability
Stackable siren functions
Relay for optional use of a strobe light, etc.
Two-tone, DTMF & Digital decoders – standard
Modular Design – no inter-board wiring
Motorola CDM750 - standard transceiver option

Options

UVARM provides three audio outputs and four relay outputs to enable the UltraVoice controller to activate other auxiliary devices. See Picture
UVTD-IP is a new UltraVoice™ controller that is IP enabled for use with a wireless broadband radio or direct wired Ethernet connection
Q-UV-IP is an upgrade retrofit kit to IP enable your current siren controller